This is the circuit diagram of electronic quiz button table. This circuit is simple, easy to build and of course it is not expensive. This quiz circuit used for four game participants. It determines the contestant who first presses the switch (S1 through S4) to answer a question and locks out the remaining three entries so the others contestant’s buttons won’t work. Simultaneously, the respective audio alarm sounds and the bulb glows. The quiz table can be used for more number of contestants simply by adding buzzers, bulbs, MOSFETs and diodes.
T1-T4 = IRFZ44
D1-D12 = 1N4007
C1-C4 = 47uf 25v
VR1-VR4 = 50K
R1-R4 = 560ohm
BZ1-BZ4 = Piezo-Buzzer
12v Battery or (Power supply DC)
S1-S4 = Push Switch
Another S1 on/off switch
BLI-BL4 = 12volt 15watt
This electronic quiz circuit provides an option for varying the time for which an individual buzzer and the corresponding bulb should be “on” after a particular competitor has pressed the push button. These timings can be set by presets VR1 through VR4 as required.
The circuit works off 12V, 1.5A power supply. The current rating of the power supply should be according to the load (wattage of bulbs). For higher-wattage bulbs, use power supply of a higher current rating. LEDs can be an alternative for low current power supply (battery).
Figure for setup-
If participant A presses switch S1, MOSFET T1 is triggered and the corresponding bulb BL1 (connected between drain of the MOSFET and 12V supply) glows and simultaneously piezobuzzer PZ1 connected in parallel to bulb BL1 sounds for the preset time. At the same time, capacitor C1 charges up to 12V, which then discharges through preset VR1. The discharging time of capacitor C1 is decided by preset VR1. For example, if preset VR1 s set for a resistance of 4.7k, it will give a delay of approximately 4 seconds, meaning that buzzer PZ1 and bulb BL1 will be “on” for 4 seconds. It also indicates that participant A is the first to press his switch. Even if any other participant, say, participant B, presses switch S2 after participant A has already pressed switch S1, buzzer PZ2 and bulb BL2 will not function since MOSFET T2 has no gate voltage to trigger because it is grounded through R2 and D1. The same principle applies for other contestants as well.
You can also use a group of LEDs to replace the bulb lamp, so you may create the better decoration for the looks of the lamp